Hunter Hydrawise Pro-HC - Performing a Reboot or Factory Default at Controller; Rebooting the Controller; Factory Resetting the Controller

3
Mounting the controller to a wall (continued)
1. Use the hole at the top of the controller as a reference and secure a 1" (25 mm) screw
into the wall. Note: Install screw anchors when attaching the controller to drywall or
masonry wall.
2. Align controller with the screw and slide the keyhole on top of the controller over
the screw.
3. Secure controller in place by installing screws in the other mounting holes.
For PHC-601-A, PHC1201-A, and PHC2401-A: If the supply cord is damaged,
it must be replaced by the manufacturer or service agent or a similarly qualied person
to avoid hazard.