Hunter Hydrawise Pro-HC - Setting Up Offline Controller Mode; Programming via Smartphone App

8
ESFRITPTTR
DE EN
CONNECTING TO A WI-FI NETWORK
When your controller is rst powered on, it will run a short wizard to connect it to your
wireless router.
If you’re not using the initial startup wizard, then go to the Wireless Settings section to
make changes. For support, please contact hunter.direct/prohchelp.
Using the wizard
1. Select your wireless network from the list shown on the controller display
and press the Conrm button on screen.
2. Enter your wireless password and press the OK button on keyboard.
When connecting to your wireless network, the Wi-Fi icon at the bottom right of the
controller screen will ash. Connecting takes about 30 seconds and when successfully
connected the Wi-Fi icon will stop ashing and stay on.
Note: If your network is not listed, check if the unit is
within wireless range.
Note: Make sure you press the OK button aer you’ve
entered your password. Pressing the Home or Back
buttons will not save your changes.