Hunter Hydrawise Ready - Success; Offline

!
Page 10
RC-024 Version 2.01
Each zone is color coded to indicate the current status of the zone as follows:
Green
Zone is scheduled to run at some time in the future.
Grey
This zone is not scheduled to run in the future.
Blue (dark)
Zone is current active.
Blue (light
Zone is waiting for another zone to finish watering and then will start immediately.
Gold
This zone is a master zone.
Viewing zone information
From the Zone Summary screen touch the zone you wish to view.
The!Zone!Status!screen!allows!you!to!view!the!following!information:!
Zone Name
This is the name of the Zone you’ve configured in the Hydrawise app.
Sensor
The current sensor state if configured in the Hydrawise app.
Water Usage
Water usage for this zone run. This is shown only if you have a flow meter installed and
the zone is currently running.
Current Indicates the current that all solenoids are using (including a master solenoid if
configured). Generally speaking, this value ranges from 200mA to 600mA depending on
the number of solenoids attached to a single zone output. The controller has a built-in
failsafe to automatically stop your zone if more than approximately 800mA is detected as
this may indicate a faulty solenoid or wiring. The!Zone!Status!screen!also!allows!you!to!
manually!start!a!zone!using!the!Run$Now!button.!When!started,!the!zone!will!run!for!the!
zone’s!default!configured!run!length.!This!can!be!overridden!by!clicking!on!Run$Time!prior!
to!manually!starting!the!zone.!
When a zone is running the Run Now button will change to Stop, allowing you to stop a running zone.
Vegetables
Zone 6