Hunter Hydrawise Ready - Test Wi-Fi on the Controller

!
Page 23
RC-024 Version 2.01
Each Preconfigured Watering Schedule determines how long a group of zones will run and how the
schedule should be modified based on your local weather. Zones will water only at your defined Program
Start Times.
To add a preconfigured watering schedule, navigate to the Zones & Schedules page in your Hydrawise
account and click on Add Watering Schedule.
Schedule Name
Give the schedule a name.
Run Time
Choose how long each irrigation zone associated with this Preconfigured
Watering Schedule will run.
Run Frequency
Choose how often each irrigation zone associated with this Preconfigured
Watering Schedule will run.
Schedule
Modification
Select how the watering schedule for this Preconfigured Watering Schedule is
modified based on temperature and rainfall. Note: if you apply this watering
schedule to a Smart (ET) Watering zone, the schedule modification is not
used.
Viewing Preconfigured Watering Schedules
You can see all your preconfigured watering schedules on the Zones & Schedules page.
If your controllers are managed by a contractor, you may also see preconfigured watering schedules that
your contractor has created. These will have a group symbol next to them as highlighted below. You can
use these preconfigured watering schedules but you can’t edit or delete them – only the contractor can do
that.
Controller Weather Stations
To change the location of your controller or the weather stations you’re subscribed to, select Weather
Stations from the menu in the top right hand corner.