Hunter Hydrawise Ready - Controller - Reboot Controller

!
Page 4
RC-024 Version 2.01
All items on each screen are color coded to
indicate which screen elements are buttons
and which screen elements indicate status
information.
GREEN screen items indicate settings that can
be changed. If you touch on the GREEN color
item, then you'll be able to change that setting.
GREY colored items indicate status information.
Touching on these has no effect.
Connecting to a WiFi Network
When your controller is first powered on, it will run a short wizard to connect your controller to your wireless
router.
If you’re not using the initial startup wizard then go to the Viewing Wireless Settings section, to change your
wireless settings.
Using the Wizard
1. Select your wireless network from the list shown on the controller display and press the Confirm
button on screen. If your network is not listed then check that the unit is within wireless range.
2. Enter your wireless password and press the OK button on keyboard. Make sure you press the OK
button after you’ve entered your password. Pressing the Home or Back buttons will not save
your changes.
When connecting to your wireless network, the WiFi Icon at the bottom right of the controller screen will
flash. Connecting takes about 30 seconds and when successfully connected the WiFi Icon will stop
flashing and stay on.
If you have issues connecting to wireless then the Viewing Wireless Settings section has more
troubleshooting information.
Viewing Wireless Settings
From the Home screen navigate to the Wireless Settings by pressing Settings > Wireless Settings.
To successfully connect the Hydrawise unit to your wireless router you will need to correctly select your
wireless router, wireless security mode, and enter your wireless password.
The current status of the controller’s connection to your wireless router is shown at the top of the screen.
The controller will automatically attempt to connect to the configured access point if a connection is lost (for
example, after power failure).
If you’re entering information into
the controller and use the Home or
Back buttons, then your changes
on that screen will not be changed.
Always use the OK or Conrm
buttons to conrm your changes.