!
Page 5
RC-024 Version 2.01
Touch on any of the green buttons to change the wireless type, security type, or password.
Configuring Wireless Name
Touching on the currently configured Wireless Name will automatically start a scan of all local wireless
routers and allow you to choose a new one.
After about 5 seconds, a list of found wireless networks will be listed. To select a wireless name, touch on
the wireless name and then touch Confirm. Do not press the Home or Back buttons after selecting your
wireless router name – these options will not save your router name.
Each time you touch a wireless name the signal strength will be shown at the bottom of the screen.
If your wireless router is not shown then check the following:
• Your Hydrawise controller is within range of your wireless router.
• Your access point is configured to accept connections from 802.11b/g wireless clients.
If your wireless router is hidden you may manually enter it by selecting Manually Enter Wireless and
typing in the name.
Configuring the Security Type
The security type configured on the controller must match the security type configured in your wireless
router. The Hydrawise unit can attempt to automatically detect this if you choose Auto Detect as the
security type.
Hydrawise supports the following security types:
• Open
• WPA Personal
• WPA2 Personal
• WPA Auto
After choosing the security type press the Confirm button.
To Next Page
Loading...
