Hunter Hydrawise Ready - Viewing Time and Date; Operating Zones from the Controller

!
Page 9
RC-024 Version 2.01
Once the controller has successfully connected to your wireless router the Test Network button can be
used to test network connectivity for troubleshooting purposes. The network test will verify connectivity to
4 destinations:
Checking WiFi
Performs a ping test to the Gateway address listed in the Network Status
screen. If this test fails, check that you don’t have MAC address filtering
enabled on your router.
Checking DNS
Performs a ping test to the DNS address listed in the Network Status screen. If
this test fails, check that the DNS address is correct – if it is wrong then correct
the DNS address under DHCP Settings on your wireless router. It is possible
that this test may fail if the DNS server doesn’t not accept ping requests which
does not indicate an issue.
Checking Internet
Performs a ping test to the Google server at IP address 8.8.8.8. This is a well
known server which accepts ping requests on the internet. If this test fails then it
indicates an issue with the internet configuration of your wireless router.
Checking Hydrawise
Performs a ping test to the Hydrawise servers. If this test fails, then it may
indicate an issue with the internet configuration of your wireless router.!
Viewing Time and Date
Time and date settings are synchronised with the settings that you configure in the Hydrawise app. The
timezone is set based on the location you entered during the app wizard.
If your controller is running as a stand-alone controller (ie. WiFi is disabled) then the date, time and
timezone will be shown on a GREEN background can be changed.
Operating Zones From the Controller
Zone Summary
From the Home screen navigate to the Zone Summary screen by pressing Zones.
The Zone summary screen shows the status of 6 zones at a time. To view the next or previous group of
zones use the Next and Previous buttons. The current range of zones that you are viewing is indicated at
the top of the screen.