!
Page 17
RC-024 Version 2.01
Adding a Zone
To add an irrigation zone, navigate to the Zones & Schedules page in your Hydrawise account and click
on Add a New Zone. The Zone wizard will be displayed.
Fill in the Zone Details:
Use a meaningful name for each irrigation zone. Zone names are displayed on the
Hydrawise controller and are used in your Hydrawise account to show run times and
allow manual modification of watering schedules.
The zone number for each irrigation zone should match the number you have used
when wiring the controller.
Choose an icon which will be used to display the zone on the dashboard. If you have
uploaded an image for this zone you can choose it to be displayed on the dashboard
instead.
Select a watering mode for this zone. A zone can use Smart (ET) watering or Time
Based watering, which are described below.
Depending on the type of watering you chose, fill in the details for Smart (ET) watering or Time Based
watering.
Smart (ET) Watering
Watering Type Choose whether to set the information manually or choose from a list of preconfigured
watering schedules.
Enter Time and Frequency: allows you to manually set the watering length and
frequency.
Use a preconfigured Watering Schedule: add a preconfigured watering schedule or
use one you’ve previously created. If your controllers are managed by a contractor, you
To Next Page
Loading...
