!
Page 19
RC-024 Version 2.01
Schedule Adjustment- Choose how to adjust the watering time based on your
weather triggers.
Use a Preconfigured Watering Schedule
If you choose to use a preconfigured Watering Schedule you can either choose from a
list of schedules you’ve previously created, or add a preconfigured watering schedule by
entering the watering length and frequency and schedule modifications as per the fields
above. If your controllers are managed by a contractor, you may see preconfigured
watering schedules that your contractor has created, which you can also use.
Cycle and Soak
Cycle and Soak is the ability to break the watering time for a zone into periods of
watering (cycle) and pause (soak) to allow the water to soak into the soil without runoff.
You can enable or disable Cycle and Soak. If you enable it, you need to specify the
cycle and soak periods:
• Cycle Time: the maximum number of minutes the zone can run for
• Soak Time: the minimum time between zone waterings to allow the water to soak
into the soil
Tuning Adjust the watering time for this zone from the calculated time. This allows you to fine
tune your watering if your zone appears to be too dry or wet.
Adding Zone Images
You can upload multiple pictures of each of your irrigation zones to the Hydrawise system. To upload an
image click on the Image Add button next to the Zone Edit button.
!
To Next Page
Loading...
