Hunter Hydrawise Ready - Account - Resetting Password

!
Page 25
RC-024 Version 2.01
Sensor Configuration
There are 2 steps to get your sensor working for each of your zones:
1. Create a new sensor in your Hydrawise account under Sensors.
Sensor Name
Give the sensor a name.
Type of Sensor
Choose the type of sensor or Creating Custom Sensor.
Standard sensor types are:
Flow meter with ¾ inch coupling
A Hydrawise ¾ inch flow meter
Flow meter with 1 inch coupling
A Hydrawise 1 inch flow meter
Rain Sensor
(Normally Closed)
A standard rain sensor – use this if you have wired the
rain sensor’s normally closed wire to the controller
Rain Sensor (Normally Open)
A standard rain sensor – use this if you have wired the
rain sensor’s normally open wire to the controller
Soil Moisture Sensor (Normally Closed
A standard soil moisture sensor – use this if you have
wired the soil moisture sensor’s normally closed wire to
the controller
Soil Moisture Sensor (Normally Open)
A standard soil moisture sensor – use this if you have
wired the soil moisture sensor’s normally open wire to
the controller
Controller
Choose the controller to which the sensor is wired.
Controller Input
Choose the input on the controller to which the sensor
is wired.
2. Once you’ve created your sensor, choose the zones which will use the sensor. You must only choose
zones that are on the same controller that the sensor is connected to.