What to do if my Hunter ICC-800M Controller display reads ‘P ERR’?
If your Hunter Controller displays 'P ERR', it signifies a ground fault in the wire to the pump start or master valve. Check the master valve or pump start wire for continuity. Replace or repair the broken wire, and ensure all wire connections are good and watertight.
How to fix a Hunter ICC-800M Controller when the display reads 'NO AC'?
If your Hunter Controller displays 'NO AC', it means there is no AC power to operate the controller and valves. Check to see if the transformer is properly installed.
What does 'ERR' mean on my Hunter ICC-800M Controller display?
If your Hunter Controller displays 'ERR', it indicates that electrical noise is entering the system. Check the SmartPort® wiring harness. If the wires were extended, they will need to be replaced with shielded cable. Contact your local distributor for information on shielded cable.
How do I turn off SEN on my Hunter Controller?
If your Hunter Controller displays 'SEN OFF', it means the rain sensor is interrupting irrigation or is not installed. Slide the Rain Sensor switch on the front panel to the bypass position to bypass the rain sensor circuit.
Why is there no display on my Hunter Controller?
If there is no display on your Hunter Controller, check the AC power wiring and correct any errors.
What to do if my Hunter ICC-800M Controller display reads a station number and ERR?
If your Hunter Controller displays a station number followed by 'ERR' (e.g., '2 ERR'), it indicates a ground fault in the wire leading to that station. You should check the station wire for continuity, replace or repair the broken wire, and ensure all wire connections are secure and watertight.
Why does my Hunter ICC-800M Controller keep repeating or continuously watering?
Your Hunter Controller might be repeating or continuously watering because of too many start times programmed. Only one start time per active program is required.
Overview of the ICC controller and its main components.
Instructions for mounting the controller and connecting power and valves.
Connecting modules, optional devices, and external systems.
System basics, schedule planning, setting date/time, start times, run times, and watering days.
Advanced programming, manual operation, hidden functions, and testing.
FAQs, troubleshooting, specifications, and FCC notice.
General| Type | Irrigation Controller |
|---|---|
| Model | ICC-800M |
| Display | LCD |
| Weather Sensor Compatibility | Yes |
| Number of programs | 4 |
| Number of start times per program | 8 |
| Maximum station run time | 12 hours |
| Warranty period | 2 years |
| Voltage | 24VAC |
| Cycle and Soak | Yes |
| Sensor Input | Yes |
| Manual Start | Yes |
| Backlit LCD | Yes |
| Enclosure Rating | NEMA 3R |
| Stations | 8 |
| Power Source | 24VAC (Transformer Included) |
| Watering Schedule | 7-day |
| Enclosure | Outdoor Rated |
To Next Page
