28
PROGRAMMING THE CONTROLLER (continued) ..............................................................
Selecting Interval Watering
This feature is convenient if you want to have a more consistent
watering schedule without having to worry about the day of the week
or the date. The interval you select is the amount of days between
watering. The days remaining indicates how many days until the
next watering. For example if you select an interval of 4 with 1 days
remaining, watering will begin tomorrow at the scheduled time.
1. Turn the dial to SET DAYS TO
WATER the triangle above
Sunday should be flashing.
2. Use the button and move
the flashing arrow cursor
above the INTERVAL
designator.
3. Press the
button. The
display will now show two
numbers, the interval and the
days remaining in the interval.
4. The number of days between waterings, or the interval will be
flashing. Use the
and buttons to select the number of
days desired between waterings.
5. Press the
button. The days remaining in the interval are now
flashing. Use the and buttons to select the number of days
until the next desired watering. One day remaining means it will
water the next day.
After programming, set dial to RUN to enable automatic execution of all
selected programs and start times.
Run
After programming is complete,
turn the dial to RUN to enable
automatic execution of all selected
programs and start times. Watering
will not occur unless dial is in the
RUN position.
Weather Sensor Bypass
With this built-in feature,
there is no need for an
additional manual bypass
switch when using rain
sensors (the ICC works
with the Hunter Mini-Clik
®
,
plus some other rain, wind,
and freeze sensors on the market today). If the system is preventing
system operation (or no sensor is installed and the switch is in the
ACTIVE position), SEN OFF will be displayed. Simply move the switch
to BYPASS and the weather sensor will be bypassed. This allows you to
use the system.
System Off
Valves currently watering will be
shut off after the dial is turned
to the SYSTEM OFF position for
two seconds. All active programs
are discontinued and watering is
stopped. To return controller to
normal automatic operation,
simply return dial to RUN position.
To Next Page
Loading...
