Hunter NODE-100

EN
The remaining battery life can be estimated from the battery-life
indicator shown on the display. The NODE can operate using either
a single nine-volt battery or using two nine-volt batteries. Using two
nine-volt batteries will yield approximately twice the battery life of a
single nine-volt battery. The battery-life indicator chart below shows
an estimate on the remaining battery life.
Full: 100–60% remaining battery life
Med: 60–25% remaining battery life
Low: 25–0% remaining battery life
Replace battery immediately!
BATTERYLIFE INDICATOR RESETTING CONTROLLER
Resetting the controller will erase the current program data and restart
the controller. A reset does not, however, delete a program saved to
permanent memory using the Easy Retrieve memory feature (see
page 12) to save a preferred program.
1. From idle mode, press and hold the
, , and keys.
2. Aer two seconds the screen will go blank. Continue to hold
the
, , and keys.
3. 12:00 will ash on the display. Release the keys.
4. The controller may show a countdown from 10 to 1 on the display,
and then 12:00  will be shown ashing when the reset is
complete. The controller can now be reprogrammed.
14