9
M3561-01 • 01/26/15 • ©2014 Hunter Fan Company
CFL Bulbs Flicker
Tap the Gear icon in the Room setup screen to visit the settings screen for the
appropriate room or fan. If Dimming Mode is on, turn off Dimming Mode. If the
problem is not corrected, unpair and re-pair the device with Dimming Mode disabled.
Fan will not start
• Make sure the power is on at the circuit breaker and the wall switch.
• Make sure that the transmitter and receiver are paired.
• Check wire connections inside of the canopy.
ON/OFF remote only works when held at close range
• Change battery.
App does not control the fan as expected
• Move the Bluetooth
®
plug-in controller to a nearby outlet within the same room. The
app will automatically reconnect with the Bluetooth
®
plug-in controller.
ON/OFF remote is not paired
The ON/OFF remote should already be paired to the fan receiver. If the ON/OFF remote
is not paired, perform the following steps:
1. To prevent faulty operation, please disconnect power from all other ceiling fans
within range while performing these steps.
2. Turn the fan power off and back on at the wall switch (or circuit breaker if necessary).
3. Within three minutes of restoring power to the fan, press and hold both the Fan
button and the Light button for at least four seconds.
Note: The lights will ash (if applicable) and the fan will turn on at low speed. This is
visual conrmation that the pairing was successful.
troubleshooting
To Next Page
Loading...
Need help?
General
