M3561-01 • 01/26/15 • ©2014 Hunter Fan Company
8
optional ON/OFF remote
pairing
No Pairing Required!
The optional ON/OFF remote is already
paired to the receiver and ready to use.
If the battery is working (the buttons
should illuminate when pressed) but
the remote does not operate the fan,
or if you would like to pair the remote
to additional receiver(s), please see
the Troubleshooting section on the
following page.
Fan Operation
Press and release the Fan button on the
remote control to turn the fan off or on.
Light Operation
Press and quickly release the Light
button on the remote control to turn the
light off or on.
operation
Light
Control
Fan
Control
maintenance
Installing/Replacing the Battery
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly.
The battery should be installed with the
positive (+) side up.
Replace with a CR2032 battery when
necessary.
Phillips
Head
Screw
Battery
Door
To Next Page
Loading...
Need help?
General
