17
Setting Days To Water
1. Turn the dial to SET DAYS TO
WATER.
2. The display will show the last program
selected (A, B, or C). You can switch to
another program by pressing the
button.
3. The controller will display currently
programmed active day schedule
information. This dial position provides
different watering options: choose to
water on specic days of the week,
or choose to water only on odd days
or even days. Each program can
operate using only one type of water
day option.
Selecting Specic Days of the Week
to Water
1. With the arrow cursor on a specic
day (the cursor always starts with
Sunday), press the button to activate
a particular day of the week to water.
Press the button to cancel watering
for that day. After pressing a button the
cursor automatically advances to the
next day.
2. Repeat step 1 until all desired days
have been selected. The selected days
arrows will show on the display to
indicate their status as ON. The last
solid arrow is the last day of watering
for that program.
Selecting Odd or Even Days
This feature will use a numbered day of
the month for watering instead of specic
days of the week (Odd days 1st, 3rd, 5th,
etc.; Even days 2nd, 4th, 6th, etc.).
1. Press the button until the arrow
cursor is above either EVEN or ODD
on the display.
2. Press the button to select or the
button to cancel either Odd Days or
Even Days. The previous selected days
of the week will revert to active if Odd
Days or Even Days is cancelled.
NOTE: The 31st of any month
and February 29 are always
“off” days if Odd watering is
selected.
Run
After programming is complete,
turn the dial to RUN to enable
automatic execution of all
selected programs and start
times. Watering will not occur
unless dial is in the RUN or RUN
(SENSOR BYPASS) position.
Weather Sensor Bypass
With this built-
in feature, there
is no need for an
additional manual
bypass switch when using rain sensors
(the SRC works with the Hunter Mini-
Clik
®
, plus some other rain, wind or freeze
sensors on the market today). If the sensor
is preventing system operation, just turn
the dial to RUN (BYPASS SENSOR) and
the weather sensor will be overridden.
System Off
Valves currently
watering will be shut
off after the dial is
turned to the SYSTEM
OFF position for two seconds. All active
programs are discontinued and watering
is stopped. To return controller to normal
automatic operation, simply return dial to
RUN position.
SRC Plus Controller
To Next Page
Loading...
Need help?
General
