12 – English
3
WARNING!
Make sure the spring does not fly
out and cause injury. Wear eye
protection.
Repair instructions
min 0,6 mm
Chain brake – dismantling
1
Unscrew the bolts and remove the clutch cover.
Disengage the chain brake before removing the
clutch cover.
Remove the chain and guide bar.
2
Turn the clutch cover over and use a screwdriver to
place pressure on the elbow joint and release the
chain brake.
Remove the screws that hold the cover over the
chain brake spring.
4
Place one hand over the spring, use a small
screwdriver to push the bottom end of the spring
and prise it upwards to release it.
Cleaning and inspection
Measure the thickness of the chain brake band. It
must be no less than 0.6 mm at any point.
• Clean all parts carefully.
• Lubricate the elbow joint with grease.
!
V-bok 340-351 Eng 99-04-15, 18.4412
To Next Page
Loading...
