English – 23
Repair instructions
Ignition module/flywheel – removal
1
Undo the cylinder cover and remove it. Undo the
four bolts on the starter assembly and lift it off.
2
Disconnect the HT lead. Release both leads from
the cable guide and remove it.
3
Remove the screws from the ignition module.
Disconnect the leads from the ignition module.
Remove the spark plug and fit piston stop
502 54 15-01 in its place.
4
Loosen the flywheel nut and unscrew it until it is
flush with the end of the shaft. Raise the washer to
check that the flywheel nut is in the right position.
5
Release the flywheel using puller 504 90 90-02.
Position the puller over the magnets and tighten
2–3 turns. Tap loose with a metal mallet.
V-bok 340-351 Eng 99-04-15, 18.4523
To Next Page
Loading...
