24 – English
Repair instructions
Replacing the generator, models 351/G
and 346XP/G
1
Remove the starter assembly, leads, cable guide,
ignition module and flywheel as described for the
other models.
2
Unbolt the cover from the front hand grip (three
bolts) and disconnect the leads.
3
Cleaning and inspection
• Clean all parts, especially the tapers on the
flywheel and shaft.
• Check that the flywheel is not cracked or dam-
aged in any other way.
Unscrew the two bolts from the generator. Lift off
the generator and pull out its lead.
4
Feed the lead from the new generator through the
hole to the connection on the front hand grip,
connect both leads and clip the lead to the fuel tank.
5
Bolt the generator in position, tightening the bolts
to a torque of 5 Nm.
6
Refit the flywheel, ignition module, cable guide,
leads and starter assembly as described for the
other models (see page 25).
V-bok 340-351 Eng 99-04-15, 18.4524
To Next Page
Loading...
