English – 25
Repair instructions
0,3 mm
Ignition module and flywheel – refitting
1
Place the flywheel on the shaft. Turn the flywheel so
that the key lines up with the keyway in the shaft.
Fit the washer and nut on the shaft and tighten to a
torque of 25-30 Nm.
2
Connect the earth lead (black) to the bolt at the
front of the ignition module. Position the ignition
module but do not tighten the bolts. Turn the
flywheel so that the magnets are beside the
ignition module.
Adjust the gap between the ignition module and
the magnet with feeler gauge 502 51 34-01. The
gap should be 0.3±0.1 mm. The gap must be
measured at either of the two lowest pegs on the
ignition module. Tighten the bolts to 4.5–6 Nm.
3
Connect the blue lead to the ignition module.
Fit the cable guide and press the leads into position.
Fit the spark plug and tighten to a torque of 15 Nm.
Connect the HT lead.
4
Refit the starter assembly, tightening the bolts to
2.5–3.5 Nm.
Fit the cylinder cover, tightening the bolts to 2–3
Nm if applicable.
V-bok 340-351 Eng 99-04-15, 18.4525
To Next Page
Loading...
