20 – English
Cleaning and inspection
Clean the parts and check the following:
• The starter cord.
• The teeth on the pulley, lubricate with oil.
• That the pawls on the flywheel are undamaged,
i.e. that they spring back towards the centre and
move freely.
• Lubricate the starter spring with light oil.
Repair instructions
WARNING!
If the recoil spring is still under
tension when the pulley is re-
moved it can fly out and cause in-
jury. Wear eye protection.
Starter assembly – removal
1
Undo the four bolts that fasten the starter assembly
to the crankcase and lift off the starter assembly.
2
Pull out about 30 cm of the cord and fasten it in the
notch in the pulley rim. Release the tension in the
return spring by letting the pulley wind backwards
slowly.
3
Remove the bolt from the centre of the pulley and
lift off the pulley.
!
V-bok 340-351 Eng 99-04-15, 18.4520
To Next Page
Loading...
