English – 19
Unscrew the two bolts from the right side of the
rear hand grip.
Remove the throttle lock and the throttle trigger
(see page 17). Pull out the heater element with the
leads still connected.
3
Remove the air filter, throttle pushrod, rubber gaiter
and carburettor (see page 31).
4
Remove the bolt from the plate at the base of the
carburettor to release the lead for the heater
element.
5
Unscrew the three bolts from the front hand grip
and remove the cover to reveal the leads. Discon-
nect the red lead.
6
Hand grip heater on models 351G and
346XPG – refitting
1
Feed the leads into the rear hand grip and insert
the heater element in the hand grip. Screw in the
two bolts through the right side of the hand grip to
secure the heater.
2
Bolt the vibration damping springs that hold the
tank unit back in place and refit the cover over the
front hand grip.
Press the black lead into the base of the carburet-
tor and connect it with the bolt.
Tighten to a torque of 3–4 Nm.
3
Run the red lead to the front hand grip and connect
it.
4
Refit the throttle trigger and throttle lock and check
that they work correctly (see page 17).
5
Repair instructions
V-bok 340-351 Eng 99-04-15, 18.4519
To Next Page
Loading...
