38 – English
Disconnect the spring from the carburettor. Discon-
nect the throttle pushrod. Press the carburettor
throttle lever towards the cylinder and pull back the
throttle pushrod with your other hand.
4
Disconnect the fuel hose from the carburettor.
Repair instructions
Unbolt the two vibration damping springs and the
stop plate. Pull the fuel hose out of the carburettor
chamber. Disconnect the HT lead.
7
Remove the fuel tank.
5
Unbolt the stop plate and vibration damping spring
from the flywheel side of the saw.
6
Cleaning and inspection
Clean all the components and check that:
• The fuel hose is undamaged.
• There are no cracks in the fuel tank.
• The tank filler cap does not leak.
• The fuel hose grommet is undamaged.
• The fuel filter is not blocked.
1
Empty the fuel tank.
2
Remove the following:
cylinder cover
air filter
clutch cover
chain and guide bar
starter assembly
cable guide
3
Fuel tank – removal
WARNING!
The fuel used in chainsaws is
harmful if inhaled, may cause
skin irritation and is highly flam-
mable.
!
V-bok 340-351 Eng 99-04-15, 18.4638
To Next Page
Loading...
