English – 15
Repair instructions
Stop switch – removal
1
Remove the cylinder cover.
2
Remove the air filter by rotating it anti-clockwise.
Disconnect both leads from the stop plate using
pliers.
3
Remove the stop plate using pliers.
4
Carefully prise the carburettor out from the left-
hand rubber mounting using a small screwdriver.
5
Push together the plastic clips on the stop switch.
Pull out the switch.
Measure the resistance by connecting a multimeter
to each of the leads on the ignition module.
The resistance must not be higher than 0.2 ohm
when the switch is in the stop position.
Stop switch – resistance measurement
Cleaning and inspection
Clean the mating surfaces and check the resist-
ance as follows:
V-bok 340-351 Eng 99-04-15, 18.4415
To Next Page
Loading...
