English – 45
Apply silicone rubber 503 26 70-01 to the surfaces
of the crankcase that mate with the bearing hous-
ing (350), lower cylinder face (340/345).
Crankcase and crankshaft on
350/345/340 – reassembly
1
Fit the bearing housing and tighten the four bolts to
a torque of 14–16 Nm.
4
Repair instructions
Lubricate the bearings with grease and press them
onto the crankshaft. Use sleeve 502 54 20-01 to fit
the bearing on the clutch side.
2
Press the crankshaft into the bearing housing.
3
5
Refit the following parts:
fuel tank page 39
piston and cylinder page 42
silencer page 14
carburettor page 35
oil pump page 30
centrifugal clutch page 30
ignition system page 25
cable guide and starter assembly page 25
cylinder cover
clutch cover
guide bar and chain
NOTE!
If a new crankshaft has been fitted the
saw must be run in for 3-4 hours with the
carburettor adjusted to the factory set-
tings.
V-bok 340-351 Eng 99-04-15, 18.4645
To Next Page
Loading...
