English – 47
NOTE!
If a new crankshaft has been fitted the
saw must be run in for 3-4 hours with the
carburettor adjusted to the factory set-
tings.
Repair instructions
Hold the clutch side of the crankcase in a vice. Pull
the crankshaft into its bearing using assembly tools
502 70 84-01 and 502 70 45-07.
2
Crankcase and crankshaft on 346XP/G
and 351/G – reassembly
1
Fit and tighten the six crankcase bolts to a torque
of 8–10 Nm. Check that the crankshaft rotates
freely.
5
Refit the following parts:
bark rest
oil pump page 28
chain tensioner
centrifugal clutch page 26
fuel tank page 38
piston and cylinder page 40
generator page 24
carburettor base plate
carburettor page 31
throttle pushrod
silencer page 14
ignition system page 23
starter assembly page 20
cylinder cover
clutch cover
guide bar and chain
4
Check that the guide pins are in place. Fit a new
gasket to the mating surface of the clutch side of
the crankcase.
3
Place the flywheel side of the crankcase over the
crankshaft and pull the two crankcase halves
together using assembly tools 502 70 84-01 and
502 70 45-06.
V-bok 340-351 Eng 99-04-15, 18.4747
To Next Page
Loading...
