Husqvarna AUTOMOWER 210 C User Manual (English)

Other manuals for Husqvarna AUTOMOWER 210 C

Operator's Manual50 pages

Technical Manual120 pages

Questions and Answers:

A
Alyssa SwansonAug 22, 2025
What to do if my Husqvarna AUTOMOWER 210 C Lawn Mower has uneven mowing results?
- M
  Michael LopezAug 22, 2025
  If your Husqvarna Lawn Mower is leaving an uneven cut, several factors could be responsible. You may need to increase the mowing time if the mower isn't running enough hours per week. If the working area is too large, try limiting it or extending the mowing time. Dull blades can also cause unevenness, so replace all blades and screws to balance the rotating parts. If the grass is too long relative to the cutting height, raise the cutting height and then lower it gradually. Also, check for grass accumulation by the blade disc or around the motor shaft, ensuring the skid plate and blade disc rotate freely; clean if necessary.
J
Janet FrederickAug 25, 2025
Why is my Husqvarna Lawn Mower leaving uneven mowing results?
- H
  hicksdanielAug 25, 2025
  If your Husqvarna Lawn Mower is mowing unevenly, there are several potential causes. You may need to increase the mowing time if the mower works too few hours per week. The working area might be too large, so consider limiting it or extending the mowing time. Dull blades can also cause uneven mowing, so replace all blades and screws to balance the rotating parts. If the grass is too long relative to the cutting height, increase the cutting height and then successively lower it. Finally, check for grass accumulation by the blade disc or around the motor shaft, ensuring the skid plate and blade disc rotate easily; remove any obstructions if needed.
C
Crystal TerryAug 25, 2025
Why is my Husqvarna AUTOMOWER 210 C not driving?
- N
  Nathaniel CarrollAug 26, 2025
  If your Husqvarna Lawn Mower isn't moving, it may be stuck on something. Free the mower and clear whatever is obstructing it. If wet grass is the issue, wait for the lawn to dry. Consider using Automower® wheel brushes (505 13 27-01) to maintain clean drive wheels and improve traction.
B
Brittney AlvarezAug 27, 2025
How to fix a blocked wheel motor on Husqvarna AUTOMOWER 210 C?
- J
  James York MDAug 27, 2025
  If the wheel motor on your Husqvarna Lawn Mower is blocked, it's likely that grass or another object has wrapped around the drive wheel. Inspect the drive wheel and remove any obstructions.
S
Sara ElliottAug 27, 2025
Why does my Husqvarna Lawn Mower have no drive?
- E
  Erik WrightAug 27, 2025
  If your Husqvarna Lawn Mower is not driving, it may be caught on something. Free the mower and rectify the reason for the lack of drive. If wet grass is the cause, wait until the lawn has dried before using the mower.
P
Patrick KnoxAug 29, 2025
What to do if Husqvarna Lawn Mower blade disc is blocked?
- M
  Michael BradfordAug 29, 2025
  If your Husqvarna Lawn Mower's blade disc is blocked, it means that grass or another object has wrapped around it. Check the blade disc and remove the grass or other object.
R
Robert JohnsonAug 30, 2025
What to do if my Husqvarna Lawn Mower has no loop signal?
- J
  Jason GreenAug 30, 2025
  If your Husqvarna Lawn Mower shows 'no loop signal', several factors could be at play. First, the loop generator/charger might not be connected to the mains, or its circuit-breaker may have tripped. Check the wall socket and reset the breaker by disconnecting and reconnecting the power cord. A broken boundary wire could also be the culprit; inspect the LED on the loop generator/charger—a flashing light indicates damage, which can be repaired with a waterproof coupler. Another reason could be a lost connection between the mower and charging station. You can relink them by changing the PIN code. Finally, ensure the boundary wire isn't routed incorrectly around an 'island', as this can disrupt the signal. Verify correct routing to resolve this.
J
joshuamorrisAug 31, 2025
What to do if my Husqvarna AUTOMOWER 210 C Lawn Mower is outside working area?
- K
  Kevin FreemanAug 31, 2025
  If your Husqvarna Lawn Mower is operating outside of its designated working area, several issues could be the cause. The boundary wire connections to the loop generator/charger might be crossed; switch them to correct this. Too steep a gradient for the boundary cable, incorrect routing around an 'island', or the boundary wire being too close to the edge of the working area can also cause this problem; ensure the boundary wire is correctly installed. Interference from metallic objects or buried cables could also be responsible, especially in isolated areas; try moving the boundary wire to mitigate this.
J
Jamie MccartySep 2, 2025
Why is my Husqvarna AUTOMOWER 210 C Lawn Mower mowing for shorter periods than usual?
- A
  Alfred MooreSep 2, 2025
  There are several reasons why your Husqvarna Lawn Mower might be mowing for shorter periods than usual. Grass or a foreign object may be blocking the blade disc or skid plate; in this case, you should dismantle and clean these parts. In high temperatures (above 25°C), this behavior is normal. If neither of these reasons applies, the battery may be spent, and you should contact your dealer to have it checked and replaced.
S
smendezSep 3, 2025
Why does my Husqvarna AUTOMOWER 210 C Lawn Mower vibrate?
- S
  Sara RodriguezSep 3, 2025
  If your Husqvarna Lawn Mower is vibrating, the blade disc might be unbalanced, or the blades could be damaged. Inspect the blades and screws, and replace them if needed.

Husqvarna AUTOMOWER 210 C Specifications

General

Cutting Width	17 cm
Recommended Lawn Area	600 m²
Working area capacity	600 m²
Battery Type	Li-Ion
Battery Voltage	18 V
Cutting Height	20-50 mm
Sound level Measured	58 dB(A)
Battery capacity	2.1 Ah
Maximum incline within the working area	25 %
Maximum Slope	25 %
Blade Type	Pivoting razor blades
Rain Sensor	Yes
Anti-Theft System	PIN code
Connectivity	No