EasyManuals Logo

Husqvarna AUTOMOWER 210 C User Manual

Husqvarna AUTOMOWER 210 C
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
24 - English
3. INSTALLATION
Tip! Use the supplied measurement gauge as a
guide when you lay out the boundary wire. This helps
you to easily set the correct distance between the
boundary wire and the boundary/obstacle.
If you intend to staple down the boundary wire:
Tip! Mow the lawn where the wire is to be laid
using a normal lawn mower or a trimmer. It will
then be easier to lay the wire close to the ground
and the risk of the mower cutting the wire off is
reduced.
Make sure to lay the boundary wire tight to the
ground and secure the staples close together with
approximately 30" between each staple. The wire
must generally lie close to the ground, so as not to
be cut off before the grass roots have grown over
it.
Use a hammer to knock down the staples in the
ground. Exercise care when knocking in the
staples and make sure the wire is not under
strain. Avoid forming the wire in sharp bends.
If you intend to bury the boundary wire:
Make sure to place the boundary wire at least
0.5" and a maximum of 8" into the ground.
The boundary wire must not be crossed on the path
to and from an island.
IMPORTANT INFORMATION
Extra wire must not be placed in coils outside
the boundary wire. This can disrupt
Automower™.
3012-281
3012-745
3012-686US

Other manuals for Husqvarna AUTOMOWER 210 C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husqvarna AUTOMOWER 210 C and is the answer not in the manual?

Husqvarna AUTOMOWER 210 C Specifications

General IconGeneral
BrandHusqvarna
ModelAUTOMOWER 210 C
CategoryLawn Mower
LanguageEnglish

Related product manuals