Husqvarna AUTOMOWER 310 MARK II User Manual

6.4 Indicator lamp in the charging station
The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
Speak to your Husqvarna customer service for more information.
Light Cause Action
Green solid light Good signals Usual operation of the product.
Green flashing light The signals are good and ECO mode is ena-
bled.
Usual operation of the product. Refer to ECO
mode on page 28 .
Blue flashing light The boundary wire is not connected to the
charging station.
Make sure that the boundary wire is correctly
installed in the charging station. Refer to To
install the boundary wire on page 18 .
Damage in the boundary wire. Find out where the damage is. Replace the
damaged section with new boundary wire.
Red flashing light Interference in the antenna of the charging
station.
Speak to your Husqvarna customer service.
Red solid light Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by an authorized service techni-
cian.
Speak to your Husqvarna customer service.
1462 - 007 - 14.03.2022 Troubleshooting - 41

Husqvarna AUTOMOWER 310 MARK II Specifications

General

Cutting width	22 cm
Cutting height, min-max	20-50 mm
Battery type	Li-ion
Typical charging time	60 min
Typical mow time on one charge	70 min
Sound level perceived	59 dB(A)
Maximum slope performance inside installation	40%
Working area capacity	1000 m²
Cutting system	3 pivoting razor blades
Weight	9.4 kg
Battery voltage	18 V
Battery capacity	2.1 Ah
Maximum area capacity	1000 m²
Noise level	59 dB(A)
Weather resistance	Yes
Security features	PIN code, alarm
Connectivity	Bluetooth
Maximum slope	25% (14°)