Select product from the Log book and the serial
number and operating data is transferred
automatically to the new application circuit board.
This requires that the product previously has been
connected to Autocheck.
• Enter the serial number manually in Autocheck
If the product never was connected to Autocheck,
the serial number must be entered manually in the
Actions - Unit replacement
menu. It is then very
important to enter the correct serial number.
• Use Service mode
If the application circuit board is replaced when
troubleshooting, and you are not sure if the
application circuit board will be kept in the product, it
is possible to temporarily skip to enter the serial
number and use the application circuit board in a so-
called
Service mode
. As long as the product is in the
Service mode
, the
Service mode
text flashes in the
display. Only Autocheck can be used to control the
product in service mode.
WARNING: Do not return the product to the
customer in
Service mode
.
5.5 Demo mode
Demo mode is used for installations in shops or
exhibitions. The blade disc does not rotate and the
product alternates between short periods of operation,
docking and charging. Demo mode can be enabled and
disabled in Autocheck or in the Tools menu.
WARNING: Do not have blades installed when
the product operates for demonstration in public
areas such as shops and exhibitions.
5.6 To recover the PIN code
1. In Autocheck, select
Actions - Advanced mower
settings - Get security code to upload the security
code to the cloud.
2. Speak to the local sales support and tell them the
serial number. They can identify the correct PIN
code.
1582 - 001 - 23.12.2020 Autocheck service tool- 17
To Next Page
Loading...
