3. Make sure the plug is screwed in completely so that
a good seal is obtained.
CAUTION: Tighten by hand so as not to
damage the plastic.
4. Fit the plastic parts with the accompanying screw
instead of the old plastic screw.
6.22 To replace the sealing strip
There is one sealing strip in the product between the
upper and lower chassis.
CAUTION: A 5 mm sealing strip must be used.
Sealing may be deficient if the wrong sealing
strip is used.
1. Start by laying one end of the sealing strip in line
with the marking on the chassis.
2. Continue laying the sealing strip clockwise around
the lower chassis.
3. Lay the other end of the sealing strip above the first
end and then out of the channel. Fasten the sealing
strip in the retainer.
1582 - 001 - 23.12.2020 Repair instructions- 35
To Next Page
Loading...
