4. Push the clips inwards and lift up to remove the
support.
5. Remove the damaged ventilation filter.
6. Clean fully around the mounting surfaces.
7. Attach the new filter. Make sure that the adhesive
surfaces attach correctly to the chassis.
8. Install in the opposite sequence.
6.13 To replace the STOP button
Note: The magnet in the STOP button must be installed
correctly for the correct operation of the STOP button. If
this is not the condition, it is necessary to replace the
STOP button.
1. Remove the top cover. Refer to
To remove and
install the top cover on page 19
.
2. Remove the body. Refer to
To remove and install
the body on page 19
.
3. Pull out one side of the stop button.
4. Pull the STOP rearward to remove it.
5. Install in the opposite sequence.
6.14 To replace the hatch
1. Remove the top cover. Refer to
To remove and
install the top cover on page 19
.
2. Remove the body. Refer to
To remove and install
the body on page 19
.
3. Remove the 2 screws for the support.
4. Push the clips inwards and lift up to remove the
support.
24 - Repair instructions 1582 - 001 - 23.12.2020
To Next Page
Loading...
