Husqvarna Automower 405X - 3.5.2 To install the charging station; Charging Station Installation; 3.5.3 To install the boundary wire; Boundary Wire Installation Procedure

6 Repair instructions
This chapter describes how to repair and change spare
parts. Refer to the Illustrated parts list (IPL) at the
manufacturer's support website.
6.1 Product overview
6.1.1 The body system
The body system is structured mechanically around the
modules that follow:
1. Top cover
2. Maintenance tool
3. Body
4. Rear bumper
5. Front bumper
3
4
5
1
2
6.1.2 The upper chassis
The upper chassis is structured mechanically around the
modules that follow:
1. Hatch to display and keypad
2. STOP button
3. Upper chassis
4. Keypad
5. Display
1
3
5
4
2
6.1.3 The lower chassis
The lower chassis is structured mechanically around the
modules that follow:
1. Front body suspension parts
2. Rear body suspension parts
3. Lower chassis
4. Front wheels
5. Rear wheels
5
2
4
3
1
Note: There are one sealing strip between the upper and
lower chassis. Always replace the sealing strip when the
product is opened.
6.1.4 The cutting system
The cutting system is structured mechanically around
the modules that follow:
1. Cutting motor
2. Blade disc
3. Height adjustment motor
3
1
2
6.2 To mount screws
It is important to mount the screws correctly. Incorrect
mounted screws may harm the product. The screw
dimension is Torx 20 when there is no other information.
18 - Repair instructions 1582 - 001 - 23.12.2020