What to do if my Husqvarna AUTOMOWER 435X AWD Lawn Mower battery is low?
If your Husqvarna Lawn Mower battery is low, it might be due to a few reasons. If the product cannot find the charging station, check the LED on the charging station and look for a break in the guide wire. Change the position of the guide wire. Also, check the installation settings for finding the charging station. If the battery is spent, perform a battery test.
Why does my Husqvarna AUTOMOWER 435X AWD Lawn Mower say 'Mower lifted'?
If your Husqvarna Lawn Mower displays 'Mower lifted', it could be because the lift sensor has been activated due to the product getting stuck, so free the product. Also, check the magnets placed in the front and rear bodies; one of the lift sensor magnets might be inverted or missing. The lift sensor may be faulty.
What to do if my Husqvarna AUTOMOWER 435X AWD rear wheel motor is blocked?
If the rear wheel motor of your Husqvarna Lawn Mower is blocked, it's likely due to grass or another object wrapped around the drive wheel. Check the drive wheel and remove any obstructions.
What to do if my Husqvarna Lawn Mower front wheel motor is blocked?
If the front wheel motor of your Husqvarna Lawn Mower is blocked, it's likely due to grass or another object wrapped around the drive wheel. Check the drive wheel and remove any obstructions.
Why is my Husqvarna AUTOMOWER 435X AWD trapped?
If your Husqvarna Lawn Mower is trapped, it is likely stuck in a small area behind a number of obstacles. Check if there are any obstacles which make it difficult for the product to move.
What to do if my Husqvarna Lawn Mower cutting system is blocked?
If the cutting system of your Husqvarna Lawn Mower is blocked, it could be due to several reasons. Inspect the blade disc and remove any grass or objects that may have become wrapped around it. If the blade disc is lying in a pool of water, move the product and fix the cause of water collecting in the working area. Make sure the blade motor has the right speed. If the front motor control board is defective, replace it. Check whether the cabling to the blade motor is damaged or faulty and repair or replace the blade motor.
What to do if my Husqvarna AUTOMOWER 435X AWD says 'Outside working area'?
If your Husqvarna Lawn Mower is operating outside the designated working area, several issues could be the cause. Check that the boundary wire is connected correctly to the charging station. Also, verify that the boundary wire has been laid according to the instructions and is not too close to the edge of the working area, or that the working area doesn't slope too much at the boundary wire. Ensure the boundary wire isn't laid in the wrong direction around an island. If there are disturbances from magnetic objects or buried cables, try moving the boundary wire or creating additional islands. If the product finds it hard to distinguish the signal from an installation close by, put the product in the charging station and generate a new loop signal.
What to do if Husqvarna AUTOMOWER 435X AWD stopped because of grass around the drive wheels?
If your Husqvarna Lawn Mower stops due to grass or other objects obstructing the drive wheels, inspect the wheels and clear away any grass or obstructions. Then, restart the mower. Should the problem persist, contact your local Husqvarna representative for further assistance.
Why does my Husqvarna AUTOMOWER 435X AWD need manual charging?
If your Husqvarna Lawn Mower requires manual charging, it may be set to the Secondary area operating mode. Put the product in the charging station. This is normal behavior, and no further action is required.
Why does my Husqvarna AUTOMOWER 435X AWD Lawn Mower have a 'Battery problem'?
If your Husqvarna Lawn Mower displays a 'Battery problem', the battery may not be connected properly or could be faulty. Dismantle the product and check that the battery is properly connected to its connector. Ensure you are using only original batteries recommended by the manufacturer. If the battery is faulty, it should be replaced.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height, Min-Max | 30-70 mm |
| Battery Type | Li-Ion |
| Typical Charging Time | 30 min |
| Typical Mow Time on One Charge | 100 min |
| Product Size, LxWxH | 93x55x29 cm |
| Maximum Slope Performance Inside Installation | 70% |
| Working Area Capacity | 3500 m² |
| Battery Voltage | 18 V |
| Battery Capacity | 5.0 Ah |
| Guide Wire | Yes |
| GPS-assisted Navigation | Yes |
| Lift Sensor | Yes |
| Tilt Sensor | Yes |
| Ultrasonic Sensor | Yes |
| Connectivity | Bluetooth, Cellular |
| Weather Resistance | Yes |
| Warranty | 2 years |
| Blade Type | Pivoting Razor Blades |
How to get assistance for the product.
Overview of the robotic lawn mower, its mowing technique, and finding the charging station.
Details the product's user interface, including display and buttons.
Introduces the mobile application for remote control and extended functions.
Visual identification of product components with numbered labels.
Explains the meaning of various symbols found on the product and battery.
Detailed guide to the product's user interface and operation.
Crucial safety information to read and keep for future reference.
Explains warning, caution, and note definitions used in the manual.
Guidelines for safe operation of the product.
Instructions for the correct and safe use of the product.
Specific safety precautions related to the product's battery.
Instructions on safely lifting and moving the product.
Safety precautions to follow during product maintenance.
Safety measures to take during thunderstorms to protect the product.
Overview of installation, components, and general preparations.
Guidance on planning boundary/guide wire placement and locations.
Step-by-step instructions for installing the charging station.
Detailed steps for installing the boundary wire.
Detailed steps for installing the guide wire.
Introduction to the mobile app, installation, pairing, and features.
Instructions on how to safely power on the product.
Explanation of available operating modes: Main, Secondary, and Park.
How to temporarily stop the product's operation.
How to safely turn off the product completely.
Instructions for charging the product's battery.
How to adjust the cutting height using the Automower® Access interface.
General advice on keeping the product in good condition.
Instructions for cleaning the product, including blade disc and chassis.
Step-by-step guide on how to replace worn or damaged blades.
Instructions for removing and installing the product's top covers.
Important safety and care instructions for the product's battery.
Recommendations for servicing the product before winter storage.
Overview of how to use the troubleshooting chapter.
Explains error icons and their meanings in the display.
Lists and explains various fault messages and their causes.
Lists and explains information messages displayed by the product.
Explains the meaning of different indicator light signals on the charging station.
Helps identify issues based on product symptoms and suggests actions.
Guide to locating and fixing breaks in the boundary loop wire.
Regulations and requirements for transporting the product.
Guidelines for storing the product safely and properly.
Procedures and regulations for disposing of the product.
Detailed specifications for dimensions, electrical system, and noise emissions.
Lists registered trademarks associated with the product.
Details the product's warranty coverage, duration, and exclusions.
Statement of compliance from the supplier.
FCC and other regulatory compliance information for US/CA markets.
To Next Page
