38 - English
4. USE
4.2 Using the timer
The lawn should not be cut too often to obtain the best
mowing result. Use the timer function (see 6.4 Timer
(2) on page 47) to avoid a downtrodden lawn and to
get the maximum life from your Automower.
For example, the quality of your lawn will improve if it is
mown every other day instead of 12 hours each day. In
addition, the grass benefits from resting completely
during at least a three-day period once a month.
4.3 Starting Automower™
1. Open the solar cell panel using the cut-out on the
back edge of the panel to access the control
panel.
2. Set the main switch to the ON position.
3. Enter the PIN code.
The default setting for the theft prevention
function Time lock (4-1-2) on Automower is
active. The function requires the PIN code to be
stated each time the main switch is moved to the
ON position when this is not done correctly the
mower will stop mowing after the set number of
days and will not start again until the correct PIN
code has been entered. The function can be
deactivated or changed as required. For more
information about Time lock (4-1-2), see
page 58.
4. Close the solar cell panel and check that the
STOP button is in the operating mode.
The message Starting is shown on the display.
5 beeps are heard over 2 seconds when the blade disc
starts.
4.4 Stopping Automower™
1. Press the STOP button.
Automower stops, the blade motor stops and the
solar cell panel cover can be opened.
3012-408
3012-814
To Next Page
Loading...
Need help?
General
