English - 43
5. CONTROL PANEL
5.2 Programs
3. A
4. B
5. C
Under the program buttons you can save sets of
different settings, to reuse or to simplify the use of
Automower in several gardens. Under respective
buttons there are some preset settings. You can
choose to use these or change them.
• To change settings: Make the required settings.
Save by holding down the selected button for
2 seconds, until two beeps are heard close
together. If, for example, button A is pressed the
message Program A changed will be shown for
2 seconds on the display.
• Use the saved information by quickly pressing the
required button.
If, for example, button A is pressed the question
Use program A? will appear on the display. If YES
is pressed, the Program A will be selected. The
letter A is then shown on the right-hand side of the
display to indicate which program is selected.
5.3 Select
6. Cancel:
• Press to go back one step in the menu structure,
or to interrupt an ongoing input.
7. YES:
• Press to confirm an entry or selection.
• Press to start the mower if more than
20 seconds has elapsed since you last pressed
a button and you want to close the solar cell
panel cover and/or set the STOP button in the
operating mode.
8. Arrow up and arrow down:
Press any of the arrow buttons to move the cursor
between menus or different selections.
3012-405
3
4
5
3012-406
67 8
To Next Page
Loading...
Need help?
General
