Maintenance
Daily Weekly
Maintenance interval in
hours
25 100 200 400 800
Replace filter in the transmission
2
* *
To clean the product
CAUTION: Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
To clean the cold air intake of the engine
1. Make sure that the cold air intake grille is not
blocked. Remove grass and dirt with a brush.
To remove the covers
To open the engine cover
1. Remove the rubber straps on both sides of the
engine cover.
2. Open the engine cover forward.
Note: To remove the engine cover fully, remove the
bolts by the hinges.
3. Tilt the seat forward.
2
Replace first time after 25 hours.
26 740 - 004 -
To Next Page
Loading...
