English – 9
Delivery and dealer service
● = Covered by this workshop manual.
❍ = Not covered by this workshop manual or operating Instructions.
▼ = Described in the operating Instructions.
1)
First change after 8 hours.
When driving with a heavy load or when the ambient temperature is high, replace every 50 hours.
2)
Clean
and replace the filter more often in dusty conditions.
3)
For daily use of the machine lubrication should be conducted twice a week.
4)
Conducted by authorised service workshop.
5)
Pro 18 only.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
• The parking brake is applied.
• The cutting unit is disengaged.
Lubricate choke control - ▼
Lubricate steering chain inside frame
tunnel - ▼
Check steering wires inside frame
tunnel 29 ●
Clean engine cooling air intake - ▼▼
Clean the air filter’s pre-filter (plastic foam) - ▼▼
Change engine oil
1)
29 ●●
Clean the air filter’s cartridge
2)
(paper filter) - ▼▼
Check/adjust cutting height setting 51 ●●
Check/adjust parking brake 33 ●●
Inspect flame guard/spark arrestor
(optional equipment) - ❍❍
Change the engine’s oil filter
(every 200 hours). - ▼▼
Replace the hydraulic oil filter
(every 200 hours)
4-5)
71 ●●
Clean/replace spark plugs - ▼▼
Replace fuel filter in pipe - ▼▼
Clean / replace pulse air filter
(Pro 15, Pro 18) 62 ●●
Clean the cooling fins - ❍❍
Check engine valve clearance
4)
- ❍❍
Check whether oil change
4)
or filter
change
4-5)
are necessary for gearbox
(every 500 hrs) 50 ●●
Replace the air filter’s pre-filter (plastic foam)
2)
- ▼▼
Replace the air filter (paper filter)
2)
(every 200 hours) - ▼▼
Carry out 300 hour service
4)
7 ●●
Maintenance interval in
hours
Daily main-
tenance
before after
Weekly
3)
main-
tenance
At least
once a
year
25 50 100 300
PageMaintenance
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
