6 – English
Delivery and dealer service
Pre-delivery service
1. Top up battery with acid and recharge for four hours.
2. Fit steering wheel, seat and any optional equipment.
3. Fit cutting unit.
4. Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be
12–15 kg (26,5-33 lb), or set to maximum lift if brush is to be fitted). Applies to BioClip and Combi.
Adjust cutting unit so that rear edge is about 2–4 mm (1/8") higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm (3/16")above the frame of the unit
at the lowest cutting height.
5. Check that the right amount of oil is in the transmission.
6. Check and adjust tyre pressure (60 kPa, 0,6 bar, 8,5 PSI).
7. Connect battery.
8. Fill with fuel and start engine.
9. Check that machine does not move in neutral.
10. Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lift lever safety switch.
Safety switch for hydrostatic transmission pedals.
11. Check engine speed Rider 15 2,900 ±100 rpm, Rider 18 3,000 ±75 rpm.
12. Tell customer about:
Need and benefits of following the service schedule.
Need and benefits of having machine serviced every 300 hours.
Service and the effect of the service journal on the machine’s second-hand value.
Application areas for BioClip and Combi.
13. Complete proof of sale, etc.
After first 8 hours
1. Change engine oil.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
