8 – English
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. Most of the points that
are not covered by this workshop manual are covered by the operator’s manual.
● = Covered by this workshop manual.
❍ = Not covered by this workshop manual or operating Instructions.
▼ = Described in the operating Instructions.
Delivery and dealer service
Check for fuel and oil leakage - ❍
Check the parking brake 33 ●
Check the engine oil level 12 ●
Check the fuel pump air filter - ▼
Check the seat safety switch 67 ●
Check the lift lever safety switch 67 ●
Check the safety switch, pedal system 67 ●
Check/clean the engine cooling air intake - ▼
Check the cutting unit: - ●
• blades are secure 60 ●
• condition of blades (sharpness,
shape, etc.) 62 ●
• blade synchronisation (90° between
BioClip) 57 ●
Check steering wires (for play, etc.) 29 ●
Check fasteners (screws, nuts, etc.) - ❍
Start engine and blades, listen for noise - ❍
Clean underside of cutting unit - ▼
Clean transmission air intake - ▼
Check battery acid level 11 ●
Check transmission oil level 13 ●
Check condition of V-belts, pulleys, etc. - ❍
Check for damage - ❍
Check tyre pressures (60 kPa/9,5 PSI) 13 ●
Check for damage to wire guide at
articulated joint - ❍
Clean thoroughly around engine - ▼
Clean thoroughly around transmission - ▼
Clean all belts, pulleys, etc. - ▼
Lubricate belt tensioner (nipple) - ▼
Lubricate triangle link (nipple) - ▼
Lubricate joints and seat skid rails. - ▼
Lubricate all wires - ▼
Lubricate joints on cutting unit - ▼
Clean inside frame tunnel - ❍
Lubricate pedal mechanism inside frame
tunnel - ▼
Lubricate the gear control - ▼
Lubricate the parking brake wire - ▼
Lubricate throttle control - ▼
Maintenance interval in
hours
Daily main-
tenance
before after
Weekly
3)
main-
tenance
At least
once a
year
25 50 100 300
PageMaintenance
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
