English – 45
9
10
8
2
1
6 Rider Pro 15 and Pro 18
7
Lift off the linkage and pull out the wire.
Unscrew both ball joints from the hydrostatic
transmission wire.
Remove the entire hydrostatic transmission wire.
Reparation instructions
Lift out the transmission wire with the linkage
attached.
Screw the front ball joint onto the new transmission
wire and tighten the lock nut.
Run the wire through the mower so that it follows
the same route as the old wire.
Refitting hydrostatic transmission wire
Remove the locking spring at the rear linkage on
the hydrostatic transmission wire. Release the
clamp under the left drive shaft.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
