36 – English
2 Rider Pro 15 and Pro 18
3
1
2
4
• Loosen the idler’s spring (1).
• Loosen the hydrostatic transmission cable (2)
from the arm (3) and the casing from the fixture
(4).
• Loosen the cable from the neutral position
contact (5).
• Loosen the brake cable from the arm under the
tank and the casing mounting from the rear
frame (6).
2 Rider 15V2
Only Rider Pro 18
• Clean, see ‘Hydraulic system\Working methods’.
• Loosen the hydraulic hoses from the hydrostatic
transmission.
• Release the brake wire spring and nuts. Prise the
wire off the brake arm (3).
• Remove the cable from the neutral position switch (4).
Reparation instructions
Replacing articulated steering bearing
1
• Remove the engine according to the earlier
description (see “Removing engine”).
• Block up the ride-on mower in front of the articulated
steering.
• Work off the drive belts.
• Release the oil tank for the transmission and move it
to one side to get at the brake wire.
• Release the tensioning wheel spring (1).
• Remove the locking spring and release the
locking spring on the linkage for throttle controll,
on the underside, and release the wire from the
underside of the axle (2).
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
