28 – English
Reparation instructions
1
Place an appropriate container to catch the petrol.
The tank holds approximately 7 litres and 17 litres
in the Pro 18.
2
Empty the petrol tank by removing the hose from
the connector under the tank.
If you do not wish to empty the tank, you can pinch
the hose with lockable welding pliers and then
remove the hose and hose clamp from the fuel
filter’s lower connector. You must then be sure to
keep the hose opening higher than the fuel level in
the tank.
3
Remove the three screws that fix the tank to the
bracket. Lower the tank and pull out the hose
through the frame of the machine (if it has been
loosened by the fuel filter).
Rider 15V2 and Pro 15
Pro 18. A screw hidden on the front of the console.
WARNING!
Petrol is highly flammable and
environmentally hazardous.
Exercise caution to avoid fire
and spillage.
Fuel tank
Removal
Fitting
1
It is easier to work if you empty the tank before
fitting. Insert the hose into place and attach it to the
fuel filter with the hose clamp. Make sure that the
hose cannot be chafed or rubbed.
2
Position the tank in the bracket, and secure with the
screws.
3
Fit the fuel hose and the hose clamp to the
connector under the tank as required. Fill with
petrol and check that there are no leaks.
IMPORTANT INFORMATION
Overly long screws can damage the tank
and cause fuel leakage on the Pro 18.
Only use screws as stated in the spare
parts catalogue.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
