1-6 INSTALLATION
P/N 3110586_A U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
MERCHANDISER LEVELING
Be sure to position merchandisers
properly. Level the merchandiser by all four
corners. Merchandiser(s) must be installed
level to ensure proper operation of the
refrigeration system, and to ensure proper
drainage of defrost water.
SERIAL PLATE LOCATION
The serial plate is located on the inside of the
merchandiser’s display area near the return air.
NOTE:
Impacts from shopping carts can cause wood to wear,
cracks, chipping or peeling. To avoid these impacts, it
is required to install a floor bumper (or alike) around
the case or other type of protection to prevent damage
to the wood.
SEALING MERCHANDISER TO FLOOR
If required by local sanitary codes, or if the
customer desires, merchandisers may be sealed
to the floor using a vinyl cove base trim.
The size needed will depend on how much
variation there is in the floor, from one end of
the merchandiser to the other. Sealing of the
lower front and rear panels on self contained
models may hamper their removal for servicing
or maintenance of the condensing unit.
NOTE:
Do not allow trim to cover any intake or discharge
grilles located in the lower front panel.
Serial Plate
To Next Page
Loading...
