Hussmann SMG8B - Handling and Leveling

P/N 3018126_E 1-3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
SMG8B & SSG8B
UNLOADING
Unloading from Trailer:
Lever Bar (also known as a Mule, Johnson
Bar, J-bar, Lever Dolly, or Pry Lever)
Move the merchandiser as close as possible to
its permanent location and remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such
as kits and shelves.
Improper handling may cause damage to the
merchandiser when unloading. To avoid dam-
age:
1. Do not drag the merchandiser out of the
trailer. Use a Johnson bar (mule).
2. Use a forklift or dolly to remove the
merchandiser from the trailer.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur.
merchandisers are not structurally
designed to support external loading
such as the weight of a person. Do not place
heavy objects on the merchandiser.
SHIPPING SKID
Each merchandiser is shipped on a skid to
protect the merchandiser’s base and to make
positioning the case easier.
Unscrew the case from the skid. The fixture
can now be lifted off the crate skid. Lift only at
base of skid! Remove any braces and/or skids
attached.
DO NOT LAY MERCHANDISER OVER
ON THE FLOOR TO REMOVE SKID.
Check floor where cases are to be set to see if
it is a level area. Determine the highest part of
the floor.
MERCHANDISER LEVELING
Be sure to position merchandisers properly.
Level the merchandiser by all four corners.
Merchandiser(s) must be installed level to
ensure proper operation of the refrigeration
system, and to ensure proper drainage of
defrost water.
Do NOT stand or walk on top of
merchandiser. Do not store items or
ammable materials atop the unit.
Remove bolts
aer case is rolled
o shipping rail.
3 places on the
front and 3 places
on the rear of the
case.
Remove bolts to be
able to roll case o
of shipping rails. 3
places on the front
and 3 places on the
rear of the case.
Shipping Brace