4.7
DT (Device Tag)
The remainder of the components in the control panel are labeled and are referred to in the documentation under the DT
heading. For example:
DT, CR6 is the Coolant relay labeled CR6.
DT, LS2 is the limit switch for Head Down function labeled LS2.
DT, MS 2M is the contactor labeled MS 2M.
DT, SS1 is the selector switch for Coolant Control, labeled SS1
Page and Row Numbers
In each title block of the project (electrical documentation) there are 2 headers, which are:
1. Page. This refers to the current page number
2. Pg. This refers to the total number of pages in the entire project and is for internal HYD·MECH use only.
On each Page there are a row of 4 digit numbers on the left of the page.
For example, Page 15 shows the numbers from 1500 to 1539.
7KH¿UVWGLJLWVUHIHUWRWKHSDJHQXPEHUZKLFKLQWKLVFDVHLVSDJH
The latter 2 digits refer to the row number, which in this case are from 00 to 39.
Whenever the electrical schematic shows a target to another page then the method described above should be used to
locate the component, device, wire etc.
The same format applies when reading the wire list or cable list as the page and row number are included on the list.
The concept of the TB1 & TB2 arrangement also applies to the S23H machine.
FOR ELECTRICAL SCHEMATICS AND COMPONENT PARTS LIST SEE
PDF ON ATTACHED CD.
To Next Page
