Hyd-Mech S-23 - Overhead Bundling (Hydraulic S20 H; S23 H)

7.3
OVERHEAD BUNDLING (HYDRAULIC S20H / S23H)
1. The relative speed of the bundling jaws and vise can be adjusted with the needle valves at each cylinder
7KHIROORZLQJVWHSVZLOOHQVXUHWKHHI¿FLHQWRSHUDWLRQRIWKHRYHUKHDGEXQGOLQJ
a) The material should be loaded into the machine vises and advanced to a position where a trim can
be performed.
b) Close the Fixed Vise until the Overhead Bundling Arm is slightly (1/32” to 1/64”) above the material
to be cut.
c) Close the ball valve located on the Fixed Overhead Bundling cylinder to lock the position of the
Overhead Bundling Arm and then operate as normal
9LVHÀRZ
control valve
%XQGOLQJÀRZ
control valve