ContaminationSensor CS General Safety Precautions
HYDAC Filtertechnik GmbH
en
Page 10
BeWa CS1000 3247149k en.doc 2004-07-12
1.6 Informal Safety Precautions
• Make sure to always keep the operating instructions in the vicinity of the product.
• Apart from the operating instructions, any and all general and local regulations
pertaining to accident prevention and environmental protection are to be made
available and observance to be maintained to them.
• Make sure to keep the safety and hazard symbols and warnings on the product in a
legible condition.
• The power plug/cord of the product is to always be pulled before opening any
components of the product. Tests conducted with the housing open may only be
performed by properly trained, certified electricians. This also applies to all repair
work or to any modifications to electric components approved by us.
• The hoses and connection fittings are to be checked daily for leakage (visual check).
The electrical components of the product are to also be regularly checked (visual
check once a month). Any loose connections or damaged cables are to be replaced
immediately.
Warning: Pressurized fluids pose a hazard to life and limb.
Consequently, the safety regulations pertaining to working with
pressurized liquids are to be adhered to at all time!
1.7 Instructions to Be Followed in the Event of an Emergency
In the event of an emergency, immediately disconnect the CS from the
power supply and from the hydraulic system! Properly dispose of any
exiting fluid in accordance with environmental guidelines.
To Next Page
Loading...
Need help?
General
