ContaminationSensor CS General Safety Precautions
HYDAC Filtertechnik GmbH
en
Page 12
BeWa CS1000 3247149k en.doc 2004-07-12
• If work to live components is required, a second individual is required who can switch off
the product at the main switch as may prove necessary.
1.11 Maintenance, Servicing and Troubleshooting
• The prescribed adjustment, maintenance/servicing and inspection work is to be
conducted in a timely fashion.
• All operating media is to be protected/isolated for the event that the product is
accidentally started up.
• The CS is to be disconnected from the power supply and protected against being
inadvertently switched back on when performing any maintenance, servicing, inspection
or repair work.
• Any screwed fittings which have been undone/removed are to be checked to see that
they have been properly resecured.
• Always check the product to see that it functions properly when performing maintenance
and servicing work.
1.12 Modifications to the CS
• Do not make any modifications (design modifications, extensions) to the CS without the
prior consent of the manufacturer.
• Any design modifications or extensions may not be made without HYDAC Filtertechnik
GmbH’s express prior written approval.
• Immediately replace any machine components which are not in perfect condition.
• Only use original (OEM) spare parts and consumables. When using non-OEM
components it cannot be ensured that they have been designed and manufactured so as
to comply with loading and safety requirements.
1.13 Cleaning the CS and Disposal of the Media and Agents Used
• The cleaning agents and flushing oils used are to be handled and disposed of properly.
• To this end, the manufacturer’s instructions pertaining to possible use, wearing of
protective clothing and gear, and proper disposal are to be adhered to.
Some cleaning agents may pose a health hazard, especially when
undiluted.
To Next Page
Loading...
Need help?
General
