INSTALLATION
Installation information
The following information given here is not an instruction, but simply meant to give the user a
better understanding of the installation.
Condition of installation
The following information given here is not an instruction, but simply meant to give the user a
better understanding of the installation.
Installation place
Install the swimming pool heat pump on a flat, horizontal, and stable surface. Maintain 1m of
open space in front of the grille and 3m on the outlet side of the ventilator. And reserve
enough space to allow access to operate controller.
Make sure that the outlet air will not be breathed in.
To perfect your installation
--Avoid directing the flow of ventilated air towards a sensitive noise zone, such as room’s
window.
--Avoid positioning pool heat pump on a surface that can transmit vibrations to dwelling.
--Try to avoid placing appliance under a tree or exposed to water or mud, which would be likely
to complicate maintenance.
Water connection
The heat pump is connected to a filtration circuit with a by-pass.
It is imperative that the by-pass is placed after the pump and the filter.
The by-pass generally consists of 3 valves.
This makes it possible to regulate the water flow which passes through the heat pump and
to isolate the heat pump completely for any maintenance work, without cutting the flow
of filtered water.
To Next Page
Loading...
